Installation kit for MAF Honeycomb 90mm / 3.5" - Alu (w/o Honeycomb)
Honeycomb weld-on adapter Aluminum for MAF
Optimal solution to install Honeycombs correctly
Since the introduction of honeycombs, the problem has often been: "How do I install the honeycomb securely and firmly in a pipe?"
This solution is ideal for all MAF/LMM engines that want or even need to calm their airflow. To determine the correct air mass/air volume, it is essential to have a smooth and harmonious air flow at the MAF sensor. However, this is often no longer the case, especially with more powerful engines. Either due to modified intakes, pipes, bends, air filter boxes, etc.... Our Honeycomb installation kit is installed in front of the MAF and calms the intake air so that the correct values can be determined by the sensor again. The aluminum ring allows the entire module to be welded to the pipe to the MAF or directly to the MAF housing. In combination with the supplied plastic fixing ring, the honeycomb grid always remains in a fixed position.
- For pipes with 89/90mm / 3.5" diameter
- Fits directly to the tube in front of the MAF sensor
- For Honeycombs with approx. 84-86mm outside diameter (our shop item No. 248647)
- Width: 33mm
- Diameter: 89mm / 3.5"
- Material: Aluminum EN AW 6061
- Engine Part: MAF Housing
- Material: Stainless Steel
- Diameter: 89/90mm
With subscribing into our free newslerrs you will receive a £10 voucher for your next order. The newsletters are a selection of technical informations, news about new products and special promotions. You can unsubscribe for free at any time.
